Certified Attic Mold Removal
for East Lansing Attic Spaces

The two most common causes of attic sheathing mold in East Lansing, MI are: (1) exhaust fans (bathroom, kitchen, sometimes dryer) terminating inside the attic rather than to the exterior — dumping moisture-laden air directly onto cold sheathing on every use cycle; and (2) inadequate soffit-to-ridge ventilation, typically from blocked eave bays (blown-in insulation burying soffit vent openings) or undersized or damaged ridge vent — reducing cross-flow and allowing warm moist air from below to condense on cold sheathing in winter. Secondary causes include roof leaks along eave edges from ice dams, damaged step flashing, or deteriorated boot seals around penetrations.

Sapstain is a common cause of unnecessary attic remediation in East Lansing, MI. We confirm whether staining is active mold or pre-existing sapstain before recommending any treatment — if it's sapstain, we'll tell you and save you the remediation cost.

IICRC guidelines permit in-place treatment of surface mold on structurally sound sheathing — defined as material where structural integrity is maintained (MC below threshold when dry, no physical delamination, no loss of rigidity from fungal digestion). Treatment consists of HEPA vacuuming to remove loose spore material, EPA-registered fungicide application, and penetrating borate for ongoing inhibition. Sections with structural delamination or through-penetration require replacement, assessed individually. Full sheathing replacement across the entire attic is rarely warranted and should require clear justification based on section-by-section structural assessment.

Signs that exhaust fans may be terminating inside your East Lansing, MI attic include: excessive moisture or frost on sheathing near bathroom ceiling locations in winter; mold growth in a pattern that follows the bathroom footprint from above; a bath fan that seems to take a very long time to clear steam from the bathroom; or discovery of flex duct that ends loosely inside the attic rather than connecting to an exterior cap. Our attic assessment includes physically tracing every exhaust fan duct from the fan housing to its termination point — inside the attic or exterior. Improperly terminated fans are among the most common findings we make during attic mold assessments in East Lansing, MI.

Our products are applied only to structural wood (sheathing, rafters) — not to the roofing material itself. We can provide SDS sheets for all products applied so you can verify with your roofing manufacturer. Most manufacturers have no restrictions on attic wood treatment by qualified contractors.